|
PICkit 3 Programmer and In-Circuit Debugger
Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer. In-circuit debugging offers these benefits:
- Low cost
- Minimum of additional hardware needed for debug
- Expensive sockets or adapters are not required
The MPLAB PICkit 3 allows debugging and programming of PICxxx and dsPICxxx Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via ICSP connector.
The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming.
PICkit 3 Features
- USB (Full speed 12 Mbits/s interface to host PC)
- Supported with VISTA, Windows XP, WIN7 (32 oraz 64bit).
- Real-time execution
- MPLAB IDE compatible
- Built-in over-voltage/short circuit monitor
- Firmware upgradeable from PC
- Supports low voltage to 2.0 volts (2.0v to 6.0v range)
- Diagnostic LEDs (power, busy, error)
- Read/write program and data memory of microcontroller
- Erase of program memory space with verification
- Freeze-peripherals at breakpoint
- Program up to 512K byte flash
PICkit3 / PICkit2 - diffrences
- extendex memory (512Kbytes)
- automatic programming voltage regulation
- extended range of programming voltage (VDD = 1.8-5V; VPP = 1.8-14V)
Zestaw zawiera: (zdjęcie powyżek):
- PicKit3 programmer/debuger x 1
- cable Mini USB x 1
- 6 pin male conektor x 1
- 6 pin female conector x 1
- user quide
- debugger guide
- PICkit 3 Debug Express Lessons
List of supported memories: HERE
|
